Turbocharger Toyota 727210 Turbo. This means that you’ll. Have to send us your old unit. As soon as we receive your old turbocharger we will transfer. Please check your turbocharger part number and OEM number. To make sure that they match the ones which you can find in our part description. Primary cause of turbocharger failure has not been eliminated. Turbocharger is not correct for the application. Oil pressure is incorrect. Oil level is incorrect. Oil flow was interrupted (inlet or outlet). There is any leak in suction system. Silicone was used to seal oil pipes. There is incorrect pressure at blow-through in piston system. There is too high temperature of exhaust fumes. There is any mechanical damage to the turbocharger components. There is incorrect pressure in the filter. There is any obstruction of the evaporate system. Under no circumstances should a vehicle be used if a turbocharger problem is suspected as this could cause further damage to the turbocharger and/or engine. 24 MONTHS GUARANTEE FOR TURBO. RECONDITIONED UNIT ON BRAND NEW PARTS. ELE/ACTUATOR IS UNDER WARANTY. BEFORE FITTING THE TURBOCHARGER. Ensure that any fault that caused the previous turbocharger to fail has been rectified. To prevent contamination of the replacement turbo, the oil feed pipe &banjo bolts MUST be replaced, irrespective of condition. Renew the oil filter and engine oil. Inspect the turbocharger oil drain pipe for kinks or carbon blockage. If in doubt, replace the pipe. Remove all crankcase breather hoses and filters. Check and clean all inlet and outlet hoses. Using a clean container to catch the oil, crank the engine over until at least ½ pint (300 ml) of oil is pumped out of the turbo oil feed pipe. This ensures any dirt or carbon particles are flushed out, which otherwise may damage the turbocharger’s bearings. Unscrew oil sump, and check flow in oil stainer if needed change it. Ensure cleanliness whilst fitting this turbo. Do NOT remove the oil feed blanking plug until ready. Do not use exhaust sealing paste or silicon. Connect the oil feed pipe (after completing point 6 above). Do not allow dirt to enter the turbocharger bearing housing. Before fitting the oil drain pipe, ensure that the blanking plug is removed (where fitted) and crank engine until engine oil flows out of the turbocharger bearing housing. Re-fit the oil drain pipe. Before starting the engine, fill the oil chamber turbo engine oil, ensure that the turbine bearing lubrication during initial start-up. Check all connections are tight, but do not over-tighten. Start engine and check for leaks. SUCH AS REMOVAL & REFITTING / HIRE OF VEHICLES ETC. TURBOCHARGERS ARE NOT RETURNABLE ONCE FITTED UNLESS SUBSEQUENTLY FOUND TO BE FAULTY. BY PURCHASING & FITTING THIS TURBOCHARGER YOU. AGREE TO ALL THE ABOVE TERMS & CONDITIONS OF SALE. The item “TURBOCHARGER 727210 Toyota Avensis Corolla 2.0 D-4D TURBO” is in sale since Saturday, May 20, 2017. This item is in the category “Vehicle Parts & Accessories\Car Parts\Turbos & Superchargers\Turbochargers & Parts”. The seller is “turbosshop” and is located in Bedford. This item can be shipped to United Kingdom.

• Brand: Unbranded